Originally Posted by jzeiler
OK I will go shoot some pics and set up an account to post them with. Thanks.
Bend the tabs out
Simulated fuel strip connector (use your imagination as I was not pulling out of the tank) with small wires inserted into the center two pins.
Put the wires into the end of the lighter and pull the trigger.
OK The shots are a bit big and so is the end of the lighter it really does not fit well into the fuel flange connector but you could still do it with some small brass tubing slipped over the male pins to bring them up and out of the connector for zapping.
Looks like the best way to do this is to remove the strip from the tank and zap it.
Would a couple of small alligator clips work to get the terminals exposed more?
If you think you're free, there's no chance of escape!