ADVrider - View Single Post - How can I prevent highway peg U-bolt from spinning on my crash bar?

Ranger Rob · 12-11-2012, 07:10 PM

Made up brackets and fitted my TOP SECRET "Ranger Hi-Way pegs" after thinking that all of the bolt-on pegs were junk. These work fantastically and can easily be clicked in, or out with your feet.
(Let's see how long it is before these get copied.....

)

Here they are "closed"

And here they are "out for use" and super comfy

You can also see that i've drilled and countersunk the Weld 86 bashplate for some more ventilation to the VR

These pegs are so much better than any generic bolt-on pegs that i found during my research.

A lot of people comment on them when i'm out and about.

I call them my "Ranger Pegs"

12-11-2012, 07:10 PM	#16
Ranger Rob Out and about... Joined: Jan 2011 Location: SE Queensland, AUSTRALIA Oddometer: 347	Throw them away and do it properly!!! Made up brackets and fitted my TOP SECRET "Ranger Hi-Way pegs" after thinking that all of the bolt-on pegs were junk. These work fantastically and can easily be clicked in, or out with your feet. (Let's see how long it is before these get copied.....) Here they are "closed" And here they are "out for use" and super comfy You can also see that i've drilled and countersunk the Weld 86 bashplate for some more ventilation to the VR These pegs are so much better than any generic bolt-on pegs that i found during my research. A lot of people comment on them when i'm out and about. I call them my "Ranger Pegs" __________________ "Everybody dies but not everyone lives"