View Single Post
Old 12-11-2012, 09:20 PM   #17
rotarygirder
Adventurer
 
Joined: Jun 2012
Oddometer: 21
I'm in the middle of my valve job right now. I tried to call a Harley dealer the other day to get individual shims and their parts department convinced me that valve shims did not exist, and I had to be thinking of valve guides.

After that conversation I went ahead and bought the Hot Cams shim set. All of the ones I will need measured within .015mm of their spec'd size, most were less than .005mm off. Not bad for $60, especially considering their size divisions are .05mm and now I have enough of these things to take care of both of my KTMs.
rotarygirder is offline   Reply With Quote