View Single Post
Old 12-12-2012, 02:56 PM   #1388
SCExpat
Ex-expat
 
SCExpat's Avatar
 
Joined: Dec 2009
Location: Caldwell, ID
Oddometer: 606
Quote:
Originally Posted by broncobowsher View Post
Drill one hole. Put the bolt in that hole. Line it up straight, check again, and again. Then drill a second hole. Put a bolt in and check again. Keep repeating until all bolted up.........
That sounds like the plan. The fender is actually riveted on.....but there is just enough clearance I could use some short bolts with locknuts. Hopefully I don't get it too crooked.
SCExpat is offline   Reply With Quote