View Single Post
Old 12-12-2012, 05:06 PM   #6964
vabuckaroo68
Gnarly!
 
vabuckaroo68's Avatar
 
Joined: May 2009
Location: Locust Dale, VA
Oddometer: 1,129
Laugh 50 Tooth Rear Sprocket Install

I installed a 50 tooth rear sprocket from Sprocket Specialists. It's all-aluminum and cost $100 including the coating. Really light. The mounting bolts probably weigh more than the sprocket. Overall fit and finish was good. I had to file the inside edge and put a slight bevel on it to make it slide over my hub. Then it tapped right into place with a rubber mallet. The bolt heads fit snugly against the inner race. I found that my current set-up of 16/45 wasn't low enough for some of the gnarly Jeep trails that I ride. Unfortunately my currnent chain isn't long enough. I'm ordering a 120 from CJ Designs. It might be hard keeping the front wheel on the ground now!

__________________
"Over the Mountains Of the Moon,
Down the Valley of the Shadow, Ride, boldly ride,"
The shade replied- "If you seek for Eldorado!" E.A.P. 1849
04 KTM 950 ADV ~ "BEASTIE", '08 KTM 450 XCR-W, Husky 360 WR/CR, Bultaco Frontera 250
vabuckaroo68 is offline   Reply With Quote