View Single Post
Old 12-15-2012, 10:38 PM   #26
digger440 OP
digger440's Avatar
Joined: Nov 2012
Location: Very northwest corner of the USA
Oddometer: 74
I had to mount the seat, I have been putting this off. It has just been sitting on the subframe and I want to build the rest of the exhaust.

so I added some pads to the rear with nutserts in the ends of the tubes and straps to bolt the seat to

I used the nutserts with bolts to use to locate the tail left to right, drilled holes in the straps and made floating hold-down that I will capture with tabs so the hold-down will "float " in order to allow adjustment front to rear and left to right.

Tail is solid as a porn star's behind
R100 cafefighter build in progress
digger440 is offline   Reply With Quote