Originally Posted by AirDale
I ordered the Dr Bean fuel pump PCB conversion as well. After following the directions carefully I tested the pump as directed and got no more than a cycle or two of the pump before it would stop working. After a few emails to Dr Bean where he assured me this was normal operation, I still was not convinced. I finally reassembled the bike completely, after the valve clearance check and carb rejetting, installed the tank and fuel lines and found I still had the same problem. It wasn't until I engaged the starter motor that the pump started pumping. I released the starter, waited for the pump to stop pumping and the bike started immediately on the second try. A quick ride around the neighborhood has revealed normal operation.
X2 did the same exact thing with the same result All is good!
KTM 950 SE
Motorcyclist prayer: Oh lord if I die, please don't let my wife sell my bikes for what I told her they cost.