View Single Post
Old 12-22-2012, 11:41 AM   #31
terryckdbf
Studly Adventurer
 
Joined: Jun 2006
Location: Perry, Ga
Oddometer: 861
Quote:
Originally Posted by WeazyBuddha View Post
So I had my friend (with lots more mechanical knowledge than I) help me set the valves on my 08 GS for the 24K service. Bike had been running fine.

All valves were about halfway where they should have been, .075mm and .15mm more or less for intake and exhaust.

All other service was done at Lonestar BMW in Austin, this is my first time taking over.

Do dealers set them tight to keep the noise level down?

Does the spec I state above (.075mm/.15mm) so tight that damage might have occurred?

Notwithstanding the single value .15mm and .30mm spec, I assume there is actually a range. What is that range?

Any body else see a problem with this?

Terry
terryckdbf is offline   Reply With Quote