Originally Posted by Harcomo
If I'm understanding you correctly, you are wanting to remove your stock plastic skid plate? The only bolts you remove are the two bolts on the front of the plate under the exhaust header. Then you just pull the plastic plate forward and out of it's slot in the rear. No bolts to remove on the rear of it.
Thanks, I went back out and wiggled it while pulling, and it came right out. Lots of dirt (dried up mud) in there. The Ricochet more or less went right in, had to take all the bolts back out though, forgot to put anti-sieze on. Did get the Cycra guards on yesterday, not so bad, just had to cut a little more off the end of the throttle tube to clear the billet so it wouldn't bind. The ManRack was easy, now to order a Wolfman tankbag, and Luggage Electrix connector. Already have it wired back to the battery, but the controller for the gloves is just clipped to the plastic that covers the radiator now. Snow here later today, show be able to go play in it a bit.