View Single Post
Old 12-29-2012, 02:48 PM   #7
steve_k
Beastly Adventurer
 
steve_k's Avatar
 
Joined: Jul 2008
Location: Rancho Bernardo (San Diego)
Oddometer: 1,029
That's some impressive stuff Kevin! I work in electronics too and should get off my butt and do some design work like that along with the normal test and repair that I do.

The Fuzeblock is a great device in my opinion and have installed them on my Vespa GTS and G650GS. The only thing I have not liked about them is having the grounds on the opposite side of the box. Would like to have + and - next to each other. I haven't investigated too much, but that's probably to reduce the cost of the PCB by not having to use additional layers.




Quote:
Originally Posted by kevin g View Post
Geotherm,

I mounted mine up in the left front at the back of the beak. There are photos in the thread below that shows the installation. One of the appealing things for me is that one can use the GPS switched power connector that is behind the oil cooler to provide the switched relay drive. The accessory connector for this is about $15.

http://advrider.com/forums/showthread.php?t=812460
steve_k is offline   Reply With Quote