View Single Post
Old 12-30-2012, 12:07 PM   #79
Voltaire
Beastly Adventurer
 
Voltaire's Avatar
 
Joined: Jun 2011
Location: Auckland,New Zealand
Oddometer: 1,196
Quote:
Originally Posted by bmwrench View Post
Using heads and/or cylinders off a 70.6mm stroke motor won't work on an R45/R65 case. The difference in stroke makes developing a decent compression ratio difficult. If you are going to use the R45 cases and crank I suggest using the stock heads with valves from an R65. Bore to 1mm oversize; you can get pistons from a number of aftermarket sources.

On the other hand, you could really cheat, taking the motor out to 750cc. As long as you don't look significantly faster than the other bikes, or win too often, no one should ask for a tear down
Yes.
Its an R65 with 450 cylinders and pistons, finding the 450 kit was hard enough and they were never imported to down under.
Where can i get oversized pistons?
cheers
Voltaire is offline   Reply With Quote