View Single Post
Old 12-30-2012, 05:47 PM   #1259
kirkster70 OP
moto junkie
 
kirkster70's Avatar
 
Joined: Aug 2008
Location: Virginia
Oddometer: 1,905
Still waiting on wheels to figure out lower leg support, so I do what still needs done...



I-beam cut to desired length with a port-a-band. Ends dressed up with the grinder. This weighs right around 140 lbs if my math is right. The whole I-beam gets the rust knocked down with a 40 grit flap wheel, then I use Pre-Kleeno to wipe off all the crud. This old beam was pretty grungy.



Then I brush on some more enamel. I'm liking this paint so far. I've only used about an inch out of a quart can.

Young guys, don't get old. This is what you can look forward to. Being excited about a fresh painted I-beam. I'll be playing in the toilet before long.


The next time a buddy tells me about a vintage bike restoration, or a cool car rebuild, I'll just say "this one time I restored an I-BEAM! Ooooooooooh!"

kirkster70 screwed with this post 12-30-2012 at 05:59 PM
kirkster70 is offline   Reply With Quote