View Single Post
Old 12-31-2012, 06:31 PM   #273
WayneC1
Beastly Adventurer
 
Joined: Oct 2008
Location: Sydney, Australia
Oddometer: 2,170
Joel was basically adding some small resistance into the circuit to reduce current and hence reduce the power output of the alternator as a stop gap measure to reduce temperature of the stator. This will not suit all people but without improvement to the cooling of the stator as per the BMW changes the failures will continue.

Fusing the stator output while a good protective measure against shorted wiring will do nothing to address the stator temperature problem
WayneC1 is offline   Reply With Quote