View Single Post
Old 01-01-2013, 04:34 AM   #5
PSchrauber
Studly Adventurer
 
PSchrauber's Avatar
 
Joined: Jan 2011
Location: Summer: Kemiö, Finland; Winter: North Germany
Oddometer: 831
I would use sheet of heat resistant multi layer seal material that is as thick as the copper gasket. I would cut it out like the copper gasket ans that's it?

If you have difficulties getting the right thickness you can mount a couple of them to the base joint, (2 to 3).
PSchrauber is offline   Reply With Quote