View Single Post
Old 01-01-2013, 11:43 AM   #789
Ian B OP
Fairing Manufacturer
 
Joined: Oct 2004
Location: BC
Oddometer: 567
Quote:
Originally Posted by Santa View Post
I am looking at one of these for my Transalp based adv bike.
I have a question, So the ABS dash seems to bolt to the top triple using the handlebar riser mount bolts like in this picture
below.



My question is, Is the ABS being compressed between the upper triple and the circular spacer on the bar riser?
Wont the ABS compress leaving slight looseness in the handlebar mount?

Also, How much does the Lynx weigh with single HID?

Thanks
Lynx weighs about 5 lbs all in.

The ABS dash has never given problems with handlebar loosening over these past 5 years. However, some risers have a 'cup' arrangement to accommodate anti vibe rubber washers and in this instance, we include large fender washers to spread the load and avoid the edges of the risers digging into the ABS.
__________________
www.britanniacomposites.com
Ian B is offline   Reply With Quote