Originally Posted by ilbiker
Their website said something different is why I asked.
Each signal comes with 2 resistors in a nicely, cut-foam, packed box. My first product from them - but Rizoma look's top notch thus far.
Note: I bought the "adapters" for a Triumph with my original order. If you'r not afraid of cutting some wires (you shouldn't be) you don't need the adapters. Cut the ones off the OEM lamp and install them to the resisters with a suitable coupler. I did this with my rears & all is well. Heres a pic:
The setup on bottom shows the resistor connected to the adapter (purchased separately
). The top setup has the resistor re-fitted with the factory male ends that I removed from the OEM signal. This saves you a we bit of room with less "bundled wire", and will save you the $24.00 that the adapters cost.