Thread: KLR250 thread
View Single Post
Old 01-07-2013, 07:37 AM   #871
Hold my beer & watch this
Joined: Oct 2008
Location: Somewhere on da Iron Range.
Oddometer: 581
I just got done rebuilding the forks on my wifes 250. For future record the damper rods use a 9/16" nut as a holder tool, the klr650 uses a 5/8" nut. I was bale to find the 650 info on the internet but not for the 250. I had to jamb a piece of 1x1 down the damper and use the air impact to spin the bolt out.

klr650 damper rod holer 5/8" nut

klr250 damper rod holder 9/16" nut
Fly Rods, Kids and a KLR
redneckdan is offline   Reply With Quote