View Single Post
Old 01-09-2013, 06:53 PM   #181
alcontrast OP
at least I'm trying
alcontrast's Avatar
Joined: May 2008
Location: central CT, USA
Oddometer: 1,626
Originally Posted by cheesebot View Post
I have these damn cracks on almost every CB350 float bowl overflow tube I have (six at last count)
six cb350's or six float bowls?

did you find a way to repair them? I bought used carbs off ebay that didn't have cracked tubes (yet) but I was thinking a simple solution could be heat shrink tubing for for electrical work.. I'm not sure how well it would stand up to gasoline and ethanol though. It would be a super easy fix if the material was fuel resistant.

When in doubt, gas it. It will either fix the problem, or at the very least end the suspense.

07 650GS / 05 DRZ400S / 72 CB350 (that hasn't run since shortly after I bought it)
alcontrast is offline   Reply With Quote