View Single Post
Old 01-10-2013, 05:36 AM   #183
MATPOC
Studly Adventurer
 
MATPOC's Avatar
 
Joined: Dec 2011
Location: Providence, near Hope
Oddometer: 926
I repaired the cracks using soldering iron... but you got to clean the tubes.

This tube is not leaking, already checked, it holds fuel in the carb once you shut the tap off, bit it literally overflows once the fuel is on, thought level was too high but it's not. I can press the float in by hand and it still leaks when I bench test it, just can't tell if its past the needle or around the whole assembly.
MATPOC is offline   Reply With Quote