View Single Post
Old 01-10-2013, 10:06 PM   #15
Pistolero OP
W. F. O.
Pistolero's Avatar
Joined: Mar 2011
Location: TN
Oddometer: 709
Originally Posted by beergut View Post
I'm not really talking about a 'kit' per-sa but vinyl is pretty easy to come by. is a great resource...a few people on other forums have used them with great success.

This guy, I found on this site has awesome graphics for the adventure:

Make sure the surface is clean, lay the vinyl, pull it, use a little heat, cut it, have fun it with it. Its pretty hard to screw up and if you do, you pull it up and lay a new sheet. I believe you could do an entire bike for less than $100.

When you scratch it, you just simple either cut it out and put new vinyl down or put a piece over it.
Yeah I have also strongly considered going that way as well... decisions decisions
Pistolero is offline   Reply With Quote