View Single Post
Old 01-13-2013, 05:21 PM   #3542
Boon Booni
Red Clay Halo
 
Boon Booni's Avatar
 
Joined: Aug 2003
Location: Richmond, Va
Oddometer: 12,857
Quote:
Originally Posted by biensur22 View Post
I see what you're saying, but my frame hole is definitely threaded. I wonder if I should just drill it out.

I like the idea of both, an I would generally prefer the kick over the center for convenience, but the stock kickstand is so flimsy I'm always affraid it's about to break off.
Well, my bike is a 2002 so there are probably some differences. The KTM side stand for my bike uses both bolt holes on the left side, one of which is the bottom "stamped" hole for the center stand. If that hole is not blocked on your bike, then maybe you can just drill it and use the side stand and center stand together. Or maybe there was a different design of center stand for your bike?

EDIT: Just looked your bike up on the Fiche, looks like it's the same setup as mine, so I don't know why that bottom bolt hole on your bike is threaded.
__________________
A little nonsense now and then is relished by the wisest men.

You can be Han Solo, and I can be another Han Solo...

Boon Booni screwed with this post 01-13-2013 at 05:31 PM
Boon Booni is offline   Reply With Quote