Originally Posted by Boon Booni
Well, my bike is a 2002 so there are probably some differences. The KTM side for my bike uses both bolt holes on the left side, one of which is the bottom "stamped" hole for the center stand. If that hole is not blocked on your bike, then maybe you can just drill it and use the side stand and center stand together.
Or maybe there was a different design of center stand for your bike?
EDIT: Just looked your bike up on the Fiche, looks like it's the same setup as mine, so I don't know why that bottom bolt hole on your bike is threaded.
So it sounds like the best solution would be to drill it out. I'm ok with that, I've had a some time to morn the loss of arbitrary threading and I've accepted it.
Did you have a stomp pad (can't think of the right name for it) welded onto your center stand for ease of use, of do you just use it as it came?