Thread: XR650R Thread!
View Single Post
Old 01-13-2013, 07:16 PM   #15758
Desertskyy
Adventurer
 
Joined: Mar 2007
Location: Boise Idaho area and So Cal
Oddometer: 20
Quote:
Originally Posted by bill pierce View Post
Wow the pic is kinda nuts Mr freak.

I ordered a manual, and waiting for it to show up. Can you guy's tell me if this snap ring on the counter shaft just holds the seal in place? The seal is weeping a bit and I would like to replace it while I'm putting a new front sprocket on.

Because I know you boys like pitchers I'll post a couple



That clip was all I pulled when changing out my counter shaft seal

If I remember correctly it just holds the seal in place and nothing else. I think I popped out the old seal with a small flat blade screw driver. I put a little grease on the new seal and pushed it in to place and reset the clip. I did it so quickly that I never really thought much about doing it.
Hope this helps

Good luck
Desertskyy is offline   Reply With Quote