If you are counting, I'd be interested in this tank as well.
I think I'll see if the tools will fit in the glove box on top. If so, that problem is solved. Besides, they would be easier to get to there anyway.
If a shallow, narrow tray could be molded into the top of the tank, just big enough to hold tire irons, that might be handy and not cut into the capacity very much.The width of a Motion Pro with the axle wrench on one end would be about right. But those could go elsewhere, like a CJ Designs Tool Box or the skid plate tool box you mentioned.
This is The Internet. Confirm for yourself anything you may see while visiting this strange and uncertain land.