View Single Post
Old 01-15-2013, 11:57 AM   #24801
duanew1
In my Pajama pants
 
duanew1's Avatar
 
Joined: Dec 2008
Location: Huntsville, AL
Oddometer: 746
tank vent?

I haven't got my TE610 all sorted out because of subframe repair. I haven't ridden it to see how much the leak is a problem. I have a question about the tank vent. I have a 2006 and I have read many complaints about weeping fuel when overfilled. One solution was an aftermarket fuel cap with the vent installed up high. I was wondering if my idea would work. To install one of these vent valves to the original vent fitting on a hose located high on the handlebars above the level of the tank.

http://www.rockymountainatvmc.com/p/...alve/tank+vent

I have searched but have only found where one person might try this approach but no feedback. This should work shouldn't it? It shouldn't be any different than attaching it to the cap should it?
__________________
Bikes I own
2008 Yamaha WR250R
1992 Yamaha XT225
2008 SYM HD200

duanew1 screwed with this post 01-15-2013 at 12:02 PM
duanew1 is offline   Reply With Quote