I haven't got my TE610 all sorted out because of subframe repair. I haven't ridden it to see how much the leak is a problem. I have a question about the tank vent. I have a 2006 and I have read many complaints about weeping fuel when overfilled. One solution was an aftermarket fuel cap with the vent installed up high. I was wondering if my idea would work. To install one of these vent valves to the original vent fitting on a hose located high on the handlebars above the level of the tank.
http://www.rockymountainatvmc.com/p/...alve/tank+vent
I have searched but have only found where one person might try this approach but no feedback. This should work shouldn't it? It shouldn't be any different than attaching it to the cap should it?