View Single Post
Old 01-16-2013, 09:05 AM   #46
rade OP
Gnarly Adventurer
 
Joined: Dec 2008
Location: Prague
Oddometer: 177
Quote:
Originally Posted by MortimerSickle View Post
Will you have some way to vent between the sections, to release the air trapped by the frame-relief indentations? so the tank can filled completely?
Very good point!!! I have some solution, but still hesitating, if it is the best one cost/saved volume.
So far I have in plan to into the "square" areas you see on the attrappe, not "T fitting" but "L" fittings collected into one tube, that will be wired under the seat, along the airbox and it will end next to the tripple clapms.



Do you have any tips - pictures for inspiration?
__________________
Rade
创创创创创创创创创创创创创创创创创创创创创
complete portfolio at: radegarage.com

rade screwed with this post 01-16-2013 at 09:32 AM
rade is offline   Reply With Quote