View Single Post
Old 01-18-2013, 04:16 PM   #1433
kirkster70 OP
moto junkie
 
kirkster70's Avatar
 
Joined: Aug 2008
Location: Virginia
Oddometer: 1,905
Quote:
Originally Posted by CaptTeach View Post
Kirk

May I suggest two books, Sheet Metal Fabrication and Advanced Sheet Metal Fabrication. They can be found in the Transportation section of Barnes and Noble. In the books they make templates from a NON corrugated cardboard but you could do the same with posterboard. Once you get all the angles figured out you lay the paper version out on the aluminum, trace, cut and bend Then weld up the small places Lots of kewl projects in there from oil tanks to building a monocoque chassis for a GTP car. One book even shows a guy repairing a Ferrari 250 GTO - one of my favorite cars!!
I think I was looking at those. Ron Covell maybe? Yep. On the want list - with a whole bunch of other things.

The more tools I amass, the more I realize I don't have. Books are definately tools. Most things I have learned in the garage have been from reading books and frequenting sites just like this one. ...and by screwing up and NOT doing it that way again.
kirkster70 is offline   Reply With Quote