View Single Post
Old 01-19-2013, 05:26 PM   #3274
Beastly Adventurer
Joined: Sep 2007
Location: Annapolis Maryland
Oddometer: 1,455
Originally Posted by Terp View Post
...rookie question for all you single-track riders w/ handguards. What's the best way to install the full bar type on the throttle side? I have seen some cut off the little lip on the end of the grip, roll back the rubber a little, take a sliver off the throttle tube, and install that way. However, I am worried about dirt and crap getting between the tube and the bars, given the guard bar doesn't cover the hole 100%...if that makes any sense.
just cut the ends off the grip and the throttle tube if needed. it's a non-issue.

if it gets a little gritty remove bark buster slide the whole throttle assembly off and clean. i end up doing that about once a year but i like my controls to feel perfect.
crofrog is offline   Reply With Quote