View Single Post
Old 01-19-2013, 06:55 PM   #8455
Will ride 4 scenery
redninja's Avatar
Joined: Dec 2007
Location: LOVELY Ignacio, CO
Oddometer: 447
Originally Posted by maverick1 View Post
Need some help.
I purchased a K&N air filter for my 2001 XT225 and after I installed it I went for a ride and the engine seemed to misfire and started to jerk when I was accelerating quickly.
I then got home and replaced the stock foam air filter took it out and it did not misfire or jerk.
What gives.
I thought with the K&N it should perform better.
When I removed the K&N filter I did notice some red filter oil drops on the mesh screen.
The only thing I can think of is that there is too much K&N red oil on the filter, but I'm not sure if that would cause the misfiring.
Any suggestions.
I tried the K&N air filter, and the bike ran terrible. I went back to the stock one, and all was good.
ADV relay rider CO/NM
redninja is offline   Reply With Quote