honda 600 oil ring?!?!?!?
im a tad confused and probably being over cautious ..so be it...anyway all my rings spec out as they should but i noticed that the oil ring(the the scrapers that go on both sides of it) buckles a bit when stuffed into the jug..and when i say buckles..i mean some areas pull away from the jug as other press on it tight...its not by alot as in i cant even take a pic of it but i KNOW its a tight fit in there...piston is a 10.5 JE unit from XR's
so do i worry about it or just toss it together?
if anyones got any words of wisdom on the re-assemble speak up id like to hear em