Thread: CB desert sled
View Single Post
Old 01-22-2013, 12:58 AM   #255
Luke OP
GPoET&P
 
Luke's Avatar
 
Joined: Aug 2004
Location: Idiotville, OR
Oddometer: 4,115
Quote:
Originally Posted by jesusgatos View Post
That airbox is off to a good start! Might try annealing that aluminum prior to bending if you're having a hard time forming it?

It's steel. 16 ga. I checked and the bender instructions say 'up to 16ga'. It's from harbor freight.

The back/top/bottom peice of the airbox will be 22ga, so it should handle that ok. I'll reinforce it just on general principle.
Luke is offline   Reply With Quote