View Single Post
Old 01-22-2013, 01:08 PM   #1178
Seth S
Safari Scramble!!!!!
 
Seth S's Avatar
 
Joined: Jul 2004
Location: sanity?
Oddometer: 4,141
The cost of the plastic piece is all up front cost in making the mold. After that you can churn out hundreds of them on a plastic injection molding machine. the composite one is cheaper than an injection mold but the overall cost never goes down by much because each one produced is fairly labor intensive.
__________________
Seth S

My intuition nearly makes up for my lack of good judgement. Just installed my new trolling motor
Seth S is offline   Reply With Quote