View Single Post
Old 01-22-2013, 10:13 PM   #1964
Zuber
Zoob
 
Zuber's Avatar
 
Joined: Sep 2004
Location: Main Street, Shedd, Oregon
Oddometer: 1,699
Quote:
Originally Posted by Gustavo.Ramos View Post
Question for tuneecu users

Yesterday uploaded a different map to my 06 990Adv. bike was not running properly, terrible flatspot at 3-4k rpm, and 23 MPG.. :(



Turned the engine off, loaded the previous map, did reset adaptation, TPS voltage went down to 0,68v. flipped key off, then on, started and it idled fine.



WTF? the tps voltage looks rather high but below that after many many tests, it kept the revs high without dropping below 3k.
I've had a bad load with TuneECU before. Very un-ballanced running, poor mileage. Loading a different map and then the desired one again fixed it.

When you load a map, TuneECU will perform a Reset Adaptation for you. You don't have to push the button again.

You can ignore the high voltage at full throttle, all TPS' are different.

So, does it run ok now?
__________________
"Dad, can I get a motorcycle when I grow up?"
"Son, you can't do both"
Zuber is offline   Reply With Quote