Quote:
Originally Posted by Adv Grifter
Shop hourly rate varies ... probably between $65 to $90 per hour. Sorting out burnt out wiring harness is very labor intensive ... especially if they give the job to the young apprentice  .
I'd guess maybe 8 hours of shop time to re-wire the bike?
You need to find a good friend who likes Beer ... and also knows how to read a wiring harness and use a VOM (volt-Ohm meter) It's not so bad for an experienced electrical guy.
If not too many of your wires are burnt ... just go back in and solder in replacement wires. Try to color match and used same gauge wire. Also, you've got to find what the original problem was ... or the same thing will happen again.
Good luck! |
I make 18/hr. New harness is like 300 bucks. Best bet is to just buy and replace it myself?