View Single Post
Old 01-26-2013, 10:05 AM   #1
woodly1069 OP
Beastly Adventurer
 
woodly1069's Avatar
 
Joined: Jun 2008
Location: Louisville, KY...really too far from the hills!
Oddometer: 1,826
"Clocking" airhead drive shaft?

Just wondering if I need to reassemble the drive shaft from my R75/5 in any relative position? See when we had it in the press and were heating it up, it went BOOM! Knocked my buddy on to the floor and then I fell down laughing at him Problem is, I guess my dumb ass must have baked the markings right off the parts... I see that there is a small hole in the largest part of the OD on the spline connection and since there is just a taper for a press fit it can line up with anything...any thoughts?

__________________
If you can't fix it with a hammer, you've got an electrical problem!
woodly1069 is offline   Reply With Quote