Quote:
Originally Posted by GoinRidin
.
Question is here;
Has Anyone removed the seal alone from the outside without removing the pump and using the shaft and c-clip to press it out as I did when replacing EVERYTHING?
I hope this is a simple $8 repair only. I don't want more down time.
But I'll fix it right if necessary.
Thanks
JT
|
It can be done, I saw a photo of someone putting two self tappers in and using the heads to pull it out, don’t go to deep as you will damage the bearing seal. I’d be tempted to make 4 small holes with an owl and thread some wire though and out, so two loops and pull it out.