View Single Post
Old 01-28-2013, 11:42 PM   #24842
1 lunger
Beastly Adventurer
 
1 lunger's Avatar
 
Joined: Mar 2011
Location: Bloomfield CT
Oddometer: 1,209
Quote:
Originally Posted by duanew1 View Post
I was hoping to get it done today but life happened so it might be couple of days. The pic below shows that the PO did. I will do something similar with some left over 1/4" aluminum stock that I have left over. The bracket actually drops the exhaust can about 1/2" and it really helps it clear the turn signal and not melt it. I am looking to keep that drop in the repair. I will get some better pics when I am done.

Take a very good look at the mid pipe with the can lowered like that, it might rub on the back of the starter or top of side case. I found mine slightly rubbing my starter in the reg position.
1 lunger is offline   Reply With Quote