View Single Post
Old 01-29-2013, 07:35 AM   #11
woodly1069 OP
Beastly Adventurer
woodly1069's Avatar
Joined: Jun 2008
Location: Louisville, KY...really too far from the hills!
Oddometer: 2,005
OK ready to go, clean and assembled. Should l attempt to "hold" the u-joint and torque the nut in place or bolt it to the transmission first? I think bolting it up makes more sense but I don't want to damage the tranny. Of couse I would hold the drive shaft while torquing...
If you can't fix it with a hammer, you've got an electrical problem!
woodly1069 is offline   Reply With Quote