View Single Post
Old 01-30-2013, 05:02 PM   #21
chollo9
Screwed the Pooch
 
chollo9's Avatar
 
Joined: Jul 2003
Location: Silk Hope, NC
Oddometer: 986
I just pulled mine from a /6. Pulled the bearing then the sprocket, for no good reason. I don't have a pic of pulling the bearing, but the setup was identical to the one below. The arms were in contact with the outer bearing race. I did use oxy acetylene, but it didn't take much.

A stiff puller is a happy puller, and IMHO a two-jaw is superior to a three.

Cut the chain with bolt cutters, much less crap going everywhere than disc cutters. The side plates are very soft and cut easily. It seems very neanderthal, but it's a better process.

__________________
"It's not that I don't like people...I just find I am happier when they're not around"
chollo9 is offline   Reply With Quote