View Single Post
Old 02-02-2013, 04:44 PM   #7042
daviethebiker
Adventurer
 
Joined: Dec 2012
Location: Watsonville, CA
Oddometer: 41
Question

I recently bought a new chain slider for the swingarm on my 1987 XL600R. When I took the swingarm off I felt reassembly was going to be tough as the swingarm was very hard to get apart from the frame. I cleaning everything and put the new chain guide on and got ready to install the swingarm but I can't get the swingarm to slide into position. Is it easier if I loosen the other engine mount in the rear ? Are there any tricks to make re-installing the swingarm easier ? Thank you.
daviethebiker is offline   Reply With Quote