View Single Post
Old 02-02-2013, 05:01 PM   #8
Downer OP
Downer
 
Downer's Avatar
 
Joined: Aug 2008
Location: Richmond, VA
Oddometer: 192
Laugh

Quote:
Originally Posted by twistedthrottle View Post
I wish I had seen this sooner. We will put together a little tutorial on that. For anyone else who reads this I suggest you to use a 9/32 bit to drill the hole. It will create a nice snug pass-through for the wire. It might not be a bad idea to put a dab of sealant where the wire exits the housing as well.

Sorry for the slow response.

Kevin
No problem. I called your customer service number and confirmed a hole was needed. The tutorial sounds like a great idea. I searched all over and could not believe the question had not been asked before. So far I love the lights.
__________________
“People who want to share their religious views with you almost never want you to share yours with them." Dave Barry
Downer is offline   Reply With Quote