View Single Post
Old 02-03-2013, 08:50 AM   #107
Leo562 OP
Adventurer
 
Joined: Jan 2013
Location: Whittier, CA
Oddometer: 22
!!!Sorry about not updating I have been sick for quite a while and i am finally in good health!!!

I just got out to the garage yesterday and I had to make a trip to the local BMW shop in order to pick up some pieces for the clutch control and the connection between the air box and the carburetor

SO I got those parts and then I got side tracked and while the transmission was still attached to the engine block I decided I would see how the swing arm went on!!

Well I attached the swing arm to the frame with the Pivot pin and the hex nut I tightened it and there was no play but there was a small gap between the frame and the swing arm!

My question to you is Should there be a piece there protecting dirt and other contaminants from going inside the swing arm?

Pics should be up later tonight I will be working today
Leo562 is offline   Reply With Quote