Hey guys,
Didn't get too much done this weekend, but i did do my rear "fender eliminator" its in two parts, the seat pan which will hold my battery/electrical's etc and the front part which will cover all of the engine. The front part looks a little low but it matches up with the seat pretty nice.
I am adding stripes to my tank, run them down the midde. Black gloss stripes, centre stripe being 1.5" wide and .5 inch flanking stripes. Thoughts on this?
I found a broken weld which I am going to fix when I weld in my new seat braces, that will all be done next weekend