View Single Post
Old 02-03-2013, 08:05 PM   #2884
Avi8tor
ADV Poser
 
Avi8tor's Avatar
 
Joined: Apr 2010
Location: Midwest
Oddometer: 211
Quote:
Originally Posted by gnath9 View Post
I printed out the templates and did some matching up and then went with this set up ...

Build Your Own Handguards 1 1/8" Bars
Choose Your Top Clamp Bolt Pattern: 106x38/40mm Bolt Pattern.
Upgrade Your Top Clamp: SX Top Clamp
Add New ProTaper Contour Fat Bars: Carmichael Bend Black
Add a Lower Clamp: None
Add Black Anodize: Add Black Anodize, Set W/Guards
Add a Mirror: Two Mirrors.

I hope I got the size right. Also have ROX risers for the fat bars.
they sure look good on your bike.
I use the Rox elite risers for the fat bars with the risers on the inside of the clamps. I ordered 96mm x 38/40 mm and the fit perfect. I don't think the clamp could have been any wider and fit.

I suggest you take the bars off and mount the Rox risers and measure the distance between the bolt holes. That's how I did mine and it was spot on.

It took over a week for them to ship...so you may have time to get it changed if you need to.
__________________
CURRENT: None
PAST:
2013 CRF250L - 2009 DL650 - 1997 GL1500SE - 2005 DR-Z400S - 2008 DL650A - 2008 ST1300 - 2009 KLR650 - 2002 DR-Z400S - 1987 RM 250 - 1980 KD-80
Avi8tor is offline   Reply With Quote