View Single Post
Old 11-29-2005, 09:47 AM   #102
CaribouCases OP
Boulder CO
 
CaribouCases's Avatar
 
Joined: May 2004
Location: Adventure Rider & Aftermarket Systems Manufacturer
Oddometer: 1,205
The cubes are a bit big and heavy. The mounting plate would have to span the passenger/pillion area to avoid rear sub-frame failure potential.

As a general update, the 1150GS system is heading to powder coat next week so it is a couple of weeks behind schedule but moving along. The F650GS prototype will be done this week and ready for testing. I have a 1200GS in the shop right now and am working on the initial design. The poor KLR is sitting outside and waiting in line behind the 1200GS.

-rog


Quote:
Originally Posted by mrr1150gs
Have you looked into the Cube Pelican cases for the top box? I think they have a 20" and a 24" cube. Would be tall enough to put a helmet in. Would need some extra support and probably have to cover the passenger seat area.
__________________
Roger Pioszak, Caribou Luggage Systems.
Please see our Pelican-Based Luggage Thread in the Vendor Forum .
www.cariboucases.com
Made in Boulder, Colorado USA
PH: 303-786-8947 Mon-Sat 8:00am-5:00pm Mountain Time Zone

CaribouCases screwed with this post 11-29-2008 at 01:56 PM
CaribouCases is offline   Reply With Quote