View Single Post
Old 02-06-2013, 03:34 PM   #9
Ravenslair OP
Gnarly Adventurer
 
Joined: Feb 2012
Location: Placer County, California
Oddometer: 430
Quote:
Originally Posted by DRONE View Post
The other thing about positioning, is to remember that the QD's come apart with just a little push against the button. So if anything bumps that button while the fuel line is under pressure you could have a fire. The first time I did mine, it wasn't until I had everything back together before I realized that one of my QD's needed to be rotated 180 degrees.

Another little trick, and I just learned this, is to buy TWO of the QD's for the crossover line and put a QD on each side. Then, when removing and replacing your tank, you don't have to fuss around trying to fish the crossover line over to the other side.
Will double-check the button placement. I am pretty sure I thought of that, but it is always good to check again. I did buy two of the 90degree QD's for just that purpose. Should make tank removal a bit easier. Thanks
Ravenslair is offline   Reply With Quote