View Single Post
Old 02-06-2013, 08:35 PM   #3364
redprimo
Gnarly Adventurer
 
Joined: Jul 2011
Location: central coast of California
Oddometer: 388
A while back I posted a request for opinions of some of the newer inverter welders because I was trying to decide between one of those and an old miller 300. yesterday I stole the welder below for $850. It came with 75' of stinger, 75' of ground lead with a heavy cast clamp, a foot pedal with 20' of cord and a Weld craft wp20 torch with 25' of cable, a water recirculation tank and a full argon cylinder with a low flow regulator. Hopefully I will have it off the trailer tomorrow and have a 50 amp outlet for it by the end of the weekend.

For those not familiar this is a Miller 330A/BP and it will put out 465 amps. They were initially made by Airco in the early 1950's and changed very little over the next 30 years. This partuicular welder was purchased new in 1983 and has not been used for the past 10 years. the inside looks nearly new and still has that new car smell.

redprimo is offline   Reply With Quote