View Single Post
Old 02-07-2013, 10:11 AM   #24867
Aey dubya
Gnarly Adventurer
 
Aey dubya's Avatar
 
Joined: Nov 2007
Location: Lincoln NE
Oddometer: 354
Quote:
Originally Posted by duanew1 View Post

Don't Want to sound like a mom here, but make sure you guys are beveling the edges when doing aluminum. It is prone to poor penetration and you might end up doing it again. On the up side if you didn't you can take a cutting disc to the back side of the joint then back weld it.
Aey dubya is offline   Reply With Quote