View Single Post
Old 02-08-2013, 06:13 PM   #8
mcmann OP
Motorcycle Maniac
mcmann's Avatar
Joined: Nov 2006
Location: Jefferson, GA
Oddometer: 2,020
Here is a pic of my try I brackets:

I re-did them with 1" wide 1/4" thick aluminum flat bar. Here is a mounted picture . . . Before I wrapped them in black.

I have double-stick foam-backed tape folded in a "V" at the top of my Moose screen to support the top (velcro adhesive-backed tape would work too).

The neoprene rubber spacers help hold the screen in place.

No plans for a KTM rally . . . But will ride Colorado late summer.

Wrapped. The try II are straight with a 45 degree bend for the shield:

If you decide to leave this screen on your bike indefinitely . . . You can support the top via 3M molding mount tape (folded in a V to match the ange of the two shields):

Vee2 "The Train", Wee2 "Muliti-Tool"
NC7X "Commuter Xtraordinaire"

mcmann screwed with this post 02-09-2013 at 07:42 AM
mcmann is offline   Reply With Quote